Sunday, 27 November 2016

Week 9 - Hair for TV and Film

In class this week we practiced curling the hair for TV and film. Continuity is key on screen, therefore curling the hair is the best way of achieving this.  The curls can be styled in a variety of different ways. Using a paddle brush you can keep the curls very natural or you can run your hands through the hair and make it more volumed.

Products used:
-       -   Curlers
-       -   Pin tail comb
-       -   Paddle brush
-       -   Pins

Process
- Brush through the hair to remove any knots
- Section the hair into either a middle parting or a side parting. This depends on the overall look you want to achieve
- Placing the curler horizontal to the head, curl the nearest section to the parting first. Make sure that you keep the hair tight and roll the curler down 
- Hold for an average of 10-12 seconds. This is dependent on the thickness of the hair. The top of the hair on the curler should be hot to touch when ready
- Pull barrel out sideways so that the curl does not drop 
- Pin in place and leave until cool. This ensures that the hair will keep its curl
- Take a section of hair that starts from the hairline and works from the bottom of the curl you already made, to the ear. Curl this away from the face keeping the curler vertical to the head
- Take the next piece of hair behind this and complete the same technique. It helps to pull the hair forwards when placing the hair in the curler so that the hair is taut. The curler will then sit flat to the head
- Complete this process again on the other side of the head. You want to be working backwards until you essentially have a straight line from one side of the head to the other 
- Using brick work, you will now curl the rest of the head 
- Start by curling the hair in sections from one side to the other
- Curl the hair under and then pin until cool
- In between the gaps of the curls you have already created you then need to make another line of curls. Using the brick work technique ensures you do not miss any sections and it makes the hair fall nicer
- Carry on completing this process until you reach the bottom of the head
- Ensuring all of the curls are cool, you can remove the pins
- Take the paddle brush and brush the curls out. Brush over the curls and underneath
- Ensure that you are not too delicate when brushing the curls because they will not fall properly
- You can style the curls using the brush
- Apply a shine spray and a finishing spray to finalise the look


Reflection

I found creating these curls fairly easy, however the main area that I struggled with was keeping the hair tight on the curler. It seemed to always become less taut the near the hair is to the scalp. Next time I complete this, I will take more time in ensuring that I keep the hair tight all of the time. I will also make sure that I keep the sections clean. In one particular section at the front of the head, one piece of hair dropped out without me realising. This was due to me pulling this section of hair from too far back, therefore it fell out of the tongs. I found using the brick work process a lot easier and it allowed me to achieve better curls. Curling the hair under is a lot easier than working vertically. Overall, I found these curls to be really effective. I thought that using a paddle brush to brush out the curls would make the curls drop, however it made it easier for me to style the hair. 

No comments:

Post a Comment